\relax 
\@writefile{toc}{\contentsline {section}{\numberline {1}Introduction}{1}}
\@writefile{toc}{\contentsline {section}{\numberline {2}Notation}{1}}
\@writefile{toc}{\contentsline {section}{\numberline {3}The SVT Communication Protocol}{2}}
\newlabel{sec:svt}{{3}{2}}
\@writefile{toc}{\contentsline {subsection}{\numberline {3.1}Cables and Connectors}{2}}
\newlabel{sec:IO}{{3.1}{2}}
\@writefile{lot}{\contentsline {table}{\numberline {1}{\ignorespaces Pinout for the SOURCE front panel connectors.}}{3}}
\newlabel{pinoutS}{{1}{3}}
\@writefile{lof}{\contentsline {figure}{\numberline {1}{\ignorespaces The DS\_, D, EP and EE signals from the input connector to the CY7C4245-10 FIFO. }}{4}}
\newlabel{fig:hb_fifo_wr}{{1}{4}}
\@writefile{lot}{\contentsline {table}{\numberline {2}{\ignorespaces Pinout for the DESTINATION front panel connectors.}}{5}}
\newlabel{pinoutD}{{2}{5}}
\@writefile{toc}{\contentsline {subsection}{\numberline {3.2} Timing specifications}{5}}
\newlabel{sec:ds_tim}{{3.2}{5}}
\@writefile{lot}{\contentsline {table}{\numberline {3}{\ignorespaces  Relevant switching characteristics of the Fifo CY7C4245-10}}{6}}
\newlabel{CY7C4245-10}{{3}{6}}
\@writefile{lof}{\contentsline {figure}{\numberline {2}{\ignorespaces The DS\_ signal timing relative to the D bus timing. Timing specs for EP and EE are the same as for the D bus. }}{7}}
\newlabel{fig:hb_ds_timing}{{2}{7}}
\@writefile{toc}{\contentsline {section}{\numberline {4}Data Format}{8}}
\@writefile{toc}{\contentsline {subsection}{\numberline {4.1}Packets and Events}{8}}
\@writefile{lot}{\contentsline {table}{\numberline {4}{\ignorespaces The SVT word. Data field definition is stream dependent.}}{8}}
\newlabel{basic}{{4}{8}}
\@writefile{lot}{\contentsline {table}{\numberline {5}{\ignorespaces Data field in the End Event word.}}{8}}
\newlabel{ee}{{5}{8}}
\@writefile{toc}{\contentsline {subsection}{\numberline {4.2}XTRP to SVT and XTRP to L2 Data Format}{9}}
\newlabel{sec:xtrp_svt}{{4.2}{9}}
\@writefile{lot}{\contentsline {table}{\numberline {6}{\ignorespaces XTRP to SVT and XTRP to L2 data streams.}}{10}}
\newlabel{typical}{{6}{10}}
\@writefile{toc}{\contentsline {subsection}{\numberline {4.3}SVT to L2 Data Format}{10}}
\newlabel{sec:svt_l2}{{4.3}{10}}
\@writefile{lot}{\contentsline {table}{\numberline {7}{\ignorespaces SVT to L2 data stream.}}{11}}
\newlabel{typicall}{{7}{11}}
\@writefile{toc}{\contentsline {section}{\numberline {5}Appendix}{11}}
\newlabel{sec:Appendix}{{5}{11}}
\newlabel{fig:io_implementation}{{5}{11}}